I re-painted a couple mid power rockets, they have 13 and 14 flights on them and were due. I painted the fin section on my ARCAS after a broken fin repair.
I also finished and painted Lowtech 5, test flight on a AT E16w was good but I need to use a larger chute the 18" TFR X type came down a little hot. I plan to fly this as my go to MPR. Payload is large enough for GPS or other electronics and could go 4000'+ on a CTI G54.
I am still working on Lowtech 4, a near MD 2 stage capable rocket. I will be doing a layer of fiberglass on the rocket and will have a "heavy" nose cone to help with CG on larger motor flights. This could see 10,000' someday on a H to H flight.
I used to fly a c6 motor with a golf T nose cone and simple fins glued on, but now I understand I need to try and recover whatever I send up. So I have a few MD c6 motor rockets with a couple feet of nylon coated cable , the golf T nose cone is attached to the shock cord and may have a small streamer. This will be a single use rocket. All up weight 1.2oz.
The other is a 2 stage c6 rmotor rocket, the booster will be single use, and the sustainer will be reusable. Rear motor eject with 3' of cable, and a small access hatch for a micro peak altimeter to see how high it goes. I will add a little nose weight as well, all up weight about 2.5oz. I will launch these off my MPR pad with a 1/4" SS rod that is 65" long.
~John