Hey folks, I did some modifications to my eggfinder: I added a LiPo battery, a switch to turn it on and I hooked the backlight up. Well, after doing this, I can’t get a fix and I tied it outside to be sure. Before I modified it, it was doing good. I can’t find any wires not well soldered. It sometimes won’t recognize the gps module and when it does, it says waiting on the Gps module and won’t leave that. When it doesn’t recognize the gps module, it just sits on Waiting for Fix. Well, the GP mini is doing its part, sending out the data with the amber light flashing. Once it said i t got a fix but would never tell what it was or no tracking info on screen. Also, when I go into to programming mode and go thru on the setup it won’t say to reset, it just sits on the last screen and the green led won’t come on the lcd rf module. What could be wrong? Thanks.