I just purchased a unbuilt Dynacom Python with tail cone.
Are you planning to build it? I have been looking for anything Dynacom for awhile.I just purchased a unbuilt Dynacom Python with tail cone.
MaybeAre you planning to build it? I have been looking for anything Dynacom for awhile.
I sure will.Awesome, Gary! When you decide to sell it; let me know!
Could you post a picture. I can't open file. ThanksHere is a Dynacom Black Widow Clone using Composite Warehouse airframe and coupler tubes and a Composite Warehouse nosecone along with the fin pattern.
Here are screenshots of the Black Widow ORK file.Could you post a picture. I can't open file. Thanks
You should also add 8 ounces of nose weight.Could you post a picture. I can't open file. Thanks
Sustainer = 28 inchesCould you post a picture. I can't open file. Thanks
I built a BW clone awhile back. I used Mach1 parts.Sustainer = 28 inches
Recovery Bay = 17 inches
Nosecone = 13.75 inches
Coupler = 12 inches (you can cut the coupler to fit whatever you choose for its use)
Yes. However, the ARC BW did not have one. It used a fiberglass centering ring with three holes drilled for three small threaded rods to hold the ring as a retainer.My genuine Dynacom BW had a tail cone
Yes you are right. Have an unbuilt Python still in the box with a tail cone.Yes. However, the ARC BW did not have one. It used a fiberglass centering ring with three holes drilled for three small threaded rods to hold the ring as a retainer.
Eric from Dynacom did custom sizes also.Interesting. My dual deployment, 80 inch long Black Widow (original kit sustainer, everything else Composite Warehouse tubes) weighs 5.4 pounds dry. [A Blast from the Past - ARC Black Widow on the forum). The 60 inch entire original kit weighed 5.8 pounds dry. I think the phenolic motor tube and the somewhat lighter CW tubing are the culprits!
You are correct, sir! It is absolutely gorgeous!This was my custom built Nike Ajax by Eric at Dynacom. It was absolutely stunning.
NiceTook delivery of a minimum diameter Scorpion kit, there is little to no fin tab to speak of and the purchase include many extra parts, some that will get used, others not so much. Looks like it will hold the AT 98/10240 with lots of room to spare. I'll do a build thread on it in time. I understand these parts have history with Stu Barrett, so I will solicit some feedback from him in the future. Its Dynacom, so its deserves the best I can throw at it.
View attachment 520842View attachment 520843
Took delivery of a minimum diameter Scorpion kit, there is little to no fin tab to speak of and the purchase include many extra parts, some that will get used, others not so much. Looks like it will hold the AT 98/10240 with lots of room to spare. I'll do a build thread on it in time. I understand these parts have history with Stu Barrett, so I will solicit some feedback from him in the future. Its Dynacom, so its deserves the best I can throw at it.
View attachment 520843!
Enter your email address to join: