stevem
Well-Known Member
- Joined
- Jun 7, 2009
- Messages
- 1,613
- Reaction score
- 0
I tried to load an E18-4W in my new 24mm RMS casing. When I went to put the grain insulator tube into the casing it went hard. I should have stopped right there but I went ahead and forced it as far as I could. It stopped with about 1/16" still sticking out one end. I could not budge the thing one way or the other. I wound up having to rip it to shreds to get it out of the casing. I had one more reload left so this time I peeled a layer of paper off of the grain insulator tube before I put it in the casing. Much better fit but am I compromising anything by removing layers of paper?
Is this common with these reloads?
Does Aerotech sell just the grain insulator tubes as spare parts?
Is this common with these reloads?
Does Aerotech sell just the grain insulator tubes as spare parts?