I'm in the process of printing a 24mm motor retainer.
https://www.thingiverse.com/thing:4058299
I printed the inside one first using PTEG with a bed temp of 70 C and a nozzle temp of 225 C. I am using the latest version of Cura as my slicer. 100% infill.
I ended up with some stringing that cleaned up OK but I was surprised to see it as it showed my that the print head would jump from one side to the other instead of just doing a circle. Is there a setting in Cura that would print the retainer in a circular motion instead of jumping from side to side? Thanks.
https://www.thingiverse.com/thing:4058299
I printed the inside one first using PTEG with a bed temp of 70 C and a nozzle temp of 225 C. I am using the latest version of Cura as my slicer. 100% infill.
I ended up with some stringing that cleaned up OK but I was surprised to see it as it showed my that the print head would jump from one side to the other instead of just doing a circle. Is there a setting in Cura that would print the retainer in a circular motion instead of jumping from side to side? Thanks.