sed6
Well-Known Member
- Joined
- Dec 29, 2015
- Messages
- 132
- Reaction score
- 41
Here's a sneak peak at my newest rocket, and it's my first 3D printed one.
The body slides over a 6" BT-20 for both strength and heat resistance. The nose is solid and weighs almost an ounce giving the rocket of stability of .75 cal with a C6-5 or about 1.75 cal with an A or 1/2-A motor.
She's 1:19 scale and dimensionally accurate save the 3:1 ogive nose which should be more like a 2:1. I went the 3:1 route for a couple of reasons. First that shorter nose cone requires 3/8" more body tube per rocket and then I can't get three rockets out of a standard 18" body tube. Also the extra weight of the larger nose provides stability for a wide range of motors. Lastly most of the other Phoenix rockets from different manufacturers have a 3:1 nose, so this matches up.
I didn't keep track each draft but I think my stickered rocket is #11 or so. I'll post my ORK and STL files soon. Thanks for looking!
The body slides over a 6" BT-20 for both strength and heat resistance. The nose is solid and weighs almost an ounce giving the rocket of stability of .75 cal with a C6-5 or about 1.75 cal with an A or 1/2-A motor.
She's 1:19 scale and dimensionally accurate save the 3:1 ogive nose which should be more like a 2:1. I went the 3:1 route for a couple of reasons. First that shorter nose cone requires 3/8" more body tube per rocket and then I can't get three rockets out of a standard 18" body tube. Also the extra weight of the larger nose provides stability for a wide range of motors. Lastly most of the other Phoenix rockets from different manufacturers have a 3:1 nose, so this matches up.
I didn't keep track each draft but I think my stickered rocket is #11 or so. I'll post my ORK and STL files soon. Thanks for looking!