Anyone out there have experience with Eggtimer Classic?
I have completed the build of my first eggtimer classic. I have it wired up on the bench to test. Following the directions it powers up correctly. Red LED, multiple beeps for about 30 sec, then one long beep, red and yellow LEDs, followed my more beeps red LED blinks to follow beeps. I’ve attached USB cable and can see USB to Serial on COM3 is Prolific, device is working properly.
I launch AVR insight on PC
Target selection
Target Remote/Serial
Baud 9600
Port COM
Ok
AVR just hangs. Not Responding. I can never get into program mode.
Any suggestions?
I have completed the build of my first eggtimer classic. I have it wired up on the bench to test. Following the directions it powers up correctly. Red LED, multiple beeps for about 30 sec, then one long beep, red and yellow LEDs, followed my more beeps red LED blinks to follow beeps. I’ve attached USB cable and can see USB to Serial on COM3 is Prolific, device is working properly.
I launch AVR insight on PC
Target selection
Target Remote/Serial
Baud 9600
Port COM
Ok
AVR just hangs. Not Responding. I can never get into program mode.
Any suggestions?