It worked!
The first launch of my complete scratch built partially 3D printed rocket went perfectly. Took 5 ignition attempts (bad connector) but once it took off it soared to over 4200ft. No one could find it until around the JLCR deployment at 600ft, in which the recovery system worked perfectly.
Very happy with the success of my first scratch built high powered rocket. I am surprised and pleased with the strength of the 3D printed components, they held up very well!
Here are some up close photos of the launch on an J270W.
The first launch of my complete scratch built partially 3D printed rocket went perfectly. Took 5 ignition attempts (bad connector) but once it took off it soared to over 4200ft. No one could find it until around the JLCR deployment at 600ft, in which the recovery system worked perfectly.
Very happy with the success of my first scratch built high powered rocket. I am surprised and pleased with the strength of the 3D printed components, they held up very well!
Here are some up close photos of the launch on an J270W.