Originally posted by Planet Andy
Drew
I remember when Route 9 was 2 lanes and also most of my senior year at RCK. [Clarification edit]Hopewell Junction is referred to as"Hopeless Jungle" yet houses there are in the 500K range cause it's close to the Taconic and 70 miles from NYC. It used to be nice and woodsy.
Andy
Originally posted by micrometer
Andy, speaking of keggers, I will never forget my senior year, coming back to school right after Memorial Day weekend...on the bus, pulling into the RCK parking lot...the top of the front of the school had this narrow green band to it...holy **** it's all empty Molson bottles - from the auditorium all the way to the end of the gym, lined up like some many dead soldiers...HUNDREDS...must have been an 1/4 mile of empties stacked on the front of the roof in that neat little row...incredible...
This one? https://jleslie48.com/gallery_models_real.htmlOriginally posted by rocketking
There HAD been a website that had pdf files that you could print & assemble paper models... I'm still trying to find the Gemini-Titan site...
Originally posted by brianc
This one? https://jleslie48.com/gallery_models_real.html
(it used to be here - https://www.lhvcc.com/egiftshop/ )
Originally posted by dtomko
but it looks good to me.
Originally posted by dtomko
Go to Delta 7 Studios site to see beautiful capsule models. You should really buy the CDs and then you can rescale any size you want - there is a sample there.
Drew
Originally posted by DeWain
Drew,
Here's a really dumb question. Is there a way to directly scale the output of a PDF when printing (e.g., is there a way to have it print at 75% of full size)? Or do you have to print out a master, slap in on the platten of a color copier and set the copier to the desired reduction/magnification?
DeWain
Originally posted by dtomko
DeWain and Mark,
I am not sure of the technicalities, but I have Acrobat Reader and what I did was set the size using Properties under Print. Don't just hit the printer icon, but use Print from the File menu. When the menu comes up, go to Properties, then Layout, then Reduce/Enlarge. Check Custom and you can set a percentage. I used 90% with my Epson Stylus 660 and the fit was perfect. I suppose I was using the printer controls; I don't think that is changing the output from Acrobat (I only have Reader anyway). I did not have a reduction in quality.
Drew
Originally posted by Stuck Fingers
I am working on my Pimp Daddy clone.
What should I use to glue the transparent fin assy together?
The Instruction say Butyrate dope. Can I still buy that in California?
Earlier in this thread somebody used CA and it was unsuccessful.
Enter your email address to join: