bradycros
Well-Known Member
- Joined
- Feb 13, 2009
- Messages
- 4,284
- Reaction score
- 10
I saw this logo rocket on the home page of www.performancehobbies.com and liked what I saw. I drew it out and started building. Because of the perspective of the logo rocket drawing, I had to make some guesstamations. If you bring up performancehobbies from the above web site, leave the frame small, scroll down to bottom of page and slide the whole frame over to the left, you can compare the logo drawing and the picture of my build side by side.
Every tube was cut by hand. Every slot, centering ring, bulkhead, nose cone, fin, baffle and tail cone was made by hand. I did it, and you can do it to.
Length: 20.5 in
Width: 3 in
Fin Span: 12 in
Motor Mount: 29 mm
Nose Cone: Balsa
Tail Cone: Card Stock
Weight: 10.7 oz
Every tube was cut by hand. Every slot, centering ring, bulkhead, nose cone, fin, baffle and tail cone was made by hand. I did it, and you can do it to.
Length: 20.5 in
Width: 3 in
Fin Span: 12 in
Motor Mount: 29 mm
Nose Cone: Balsa
Tail Cone: Card Stock
Weight: 10.7 oz
Last edited: