Sold PML 6" Dia BullDog with PML Glassed and Finished body tube

[wadavidson]

PML 6" dia Bulldog kit. I had PML glass and finish the body tube so it is ready for primer and paint. Fiberglass Nose cone and Boat tail. Boat tail has small crack in the bottom but is easy to repair during the build.
All components plus a few extra parts are included. Cannot get these right now especially with a glassed tube.
Asking $400 shipped to your door.

 

[jd2cylman]

@rfjustin
Just a little bit bigger than the one that had the Cato…

 

[hball55]

That thing deserves a 75mm mmt. I replaced the phenolic body tube on mine with a 3’ piece of filament wound fiberglass from Hawk Mountain.

 

[rfjustin]

@rfjustin
Just a little bit bigger than the one that had the Cato…

I have a line on another 5" glass one the next time I can meet up with the seller. He's the nicest guy I know... you know him....

 

[slydoh]

I have an older 6" PML glassed DD Patriot unbuilt in my closet. It came with a 54mm MMT. It will be a while so if/when I build it I'm going to look at moving to a 75mm MMT.

 

[n3tjm]

I wish I had a spare $400 .

 

[OzHybrid]

Hmmm $400 shipped to my door............

 

[wadavidson]

Hmmm $400 shipped to my door............

Yup!

 

[OzHybrid]

I've PM'd you @wadavidson

 

[slydoh]

I was just typing this up when I saw the response.

"Wow. $400 shipped to Australia. As a private/regular shipper I'm sure I would pay hundreds to send this over there.
How about $250 to TX."

Best of luck Norman. Have fun.

 

[hball55]

Alls well that ends well.

 

[OzHybrid]

I've not seen any PayPal request.