Nick@JET
Well-Known Member
- Joined
- Sep 1, 2011
- Messages
- 1,693
- Reaction score
- 20
I'm using first time a PET2 for air start.
Timer 1 - will air start 2 outboard motors 1.6 seconds after Main Engine cut off.
The default settings are actually close to what I need, but I went through the settings menu to adjust my timer 1 from the default setting of 0.2 seconds to 1.6 seconds.
1. So I hook up an Ematch to channel 1,
2. Stand my rocket up
3. Power up PET2
When I power up (after setup) I get a long buzz followed by 4 yellow flashing chirps then repeat. The manual says this is "auto axis detection and no valid orientation detection".
Is this a wrong setting on my part?
Can you explain this error so I can correct?
Thanks for your help.
Details not relevant
LOC Magnum central K711 - air start 2 H195
Timer 1 - will air start 2 outboard motors 1.6 seconds after Main Engine cut off.
The default settings are actually close to what I need, but I went through the settings menu to adjust my timer 1 from the default setting of 0.2 seconds to 1.6 seconds.
1. So I hook up an Ematch to channel 1,
2. Stand my rocket up
3. Power up PET2
When I power up (after setup) I get a long buzz followed by 4 yellow flashing chirps then repeat. The manual says this is "auto axis detection and no valid orientation detection".
Is this a wrong setting on my part?
Can you explain this error so I can correct?
Thanks for your help.
Details not relevant
LOC Magnum central K711 - air start 2 H195