Jeffrey McCartney
New Member
- Joined
- Jun 3, 2019
- Messages
- 2
- Reaction score
- 0
Welcome!
In the centering rings (CR), cut a very small notch on the inside diameter. Then glue them in place on the motor tube, with the notches aligned. Fish a straw between the two notches, and glue in place. Then using some Kevlar line, fish it inside the straw, and tie a loop with a slip knot on the end that will be on the bottom, and wrap it around the motor tube. You then install your mount normally (making sure to keep the kevlar line out of the way). Tie your shock cord of choice to the top end of the kevlar.
So I can’t use Kevlar up to the cone? Was looking to cut cone 1/8 ply bulkhead and tie. I have never used the nomex madcow reusable wadding I’m guessing that is tied to the Kevlar also the. I burrito loosely the chute in it. Stuff into nosecone and loose for the cone on rocket? Trying to avoid the pitfalls.