SteveNeill
SNG Studio Ventura
Thanks so much you Thirsty Barbarian. I'll check it out. Nice you put all the info here s I can refer back to it in this thread.
Here is a list of Pro Series II models:
9711: n/a
9714: (online only model using Ventris fins, according to John Boren)
9717: ?
9718: ?
Here is a list of Pro Series II models:
9700: Leviathan
9701: Ventris
9702: Partizon
9703: Argent
9704: Nike Smoke
9705: Mega Der Red Max
9706: Ascender
9707: Majestic
9708: Mammoth
9709: Trajector
9710: Prowler
9711: n/a
9712: Scion
9713: Sahara
9714: (online only model using Ventris fins, according to John Boren)
9715: Panavia
9716: Star Orbiter
9717: ?
9718: ?
9719: Super Big Bertha
9752: Booster
The Sahara was online only as well and used the same fins as the Partizon and the body from the Argent.
The original series were the ones i was referring toz.Don't forget the Prowler.
And these are the Pro Series II.
There was a Pro Series (I) back in the day, decades ago.
Impulse, Patriot, HoJo, Maxi Force, Jayhawk...… there may be others (V-2?)
Oh, and for PSII there is the Star Orbiter, and the builders kits, which was only available from the Estes website: Panavia and Scion. I probably missed a couple.
Laters.
Just received a couple sets of Leviathan fins from Big Red Daddy for my clones, they are well made, fast shipping, well packaged for safe arrival, and I do not think that I could have purchased the plywood for the cost of the fins, great value. If you are doing PS II clones, definitely check with Big Red Daddy for the parts. I am assuming the full kits are just as satisfactory.
Just received a couple sets of Leviathan fins from Big Red Daddy for my clones, they are well made, fast shipping, well packaged for safe arrival, and I do not think that I could have purchased the plywood for the cost of the fins, great value. If you are doing PS II clones, definitely check with Big Red Daddy for the parts. I am assuming the full kits are just as satisfactory.
If you would like to read about the history of the 'original' Estes Pro Series kits and the part I played in their creation ( ) click on the link below to a thread about it on YORF:
https://forums.rocketshoppe.com/showthread.php?t=8736
Unfortunately the link to your enertek story has been lost to the gods of internet time
Curious why you reposted my scan of those fins w/o any comments on why?
Curious why you reposted my scan of those fins w/o any comments on why?
I see... When importing fin shapes into OR, the fin needs to point to the left, with the root edge at the bottom. I probably mirrored the image to allow me to do that.In the first pic, the image was backwards. I reversed it and re-posted it.
Dave F.
Enter your email address to join: