Motor sticking-out-distance in OR, and other stuff

[prfesser]

I'm probably just not looking in the right place but I can't see where you change overhang length of the motor in OR. Seems to be stuck at 1/2".

Also...is there a way to make fins conform to a tailcone? I'm doing an Astron Sprint and would like to move the fins back to the tailcone, but the root edge doesn't contact the tailcone. Ideas?

 

[neil_w]

I'm probably just not looking in the right place but I can't see where you change overhang length of the motor in OR. Seems to be stuck at 1/2".

Motor Overhang:

Also...is there a way to make fins conform to a tailcone? I'm doing an Astron Sprint and would like to move the fins back to the tailcone, but the root edge doesn't contact the tailcone. Ideas?

Use a freeform finset and attach it to the tailcone. You can convert your existing fins to freeform, rather than entering elliptical fins by hand.