gary7
Well-Known Member
I really like Loc kits and parts. About the only issue I have is the nose cone mold seam. This one also has a couple of mild imperfections.
Question: how do you fill and finish these?
I have used Bondo Glazing and Spot Putty on these with some success. But I recently ruined a nose by just a bit of over sanding. Wasn't able to get the fuzz off even going thru the numbers down to 600 grit. Paint job shows it. In fact it's ugly.
Before paint, I use Duplicolor wipes and Adhesion Promoter Primer. That Bondo glazing will adhere to primers rather well too although I have not tried it on the adhesion promoter that I can recall.
Question: how do you fill and finish these?
I have used Bondo Glazing and Spot Putty on these with some success. But I recently ruined a nose by just a bit of over sanding. Wasn't able to get the fuzz off even going thru the numbers down to 600 grit. Paint job shows it. In fact it's ugly.
Before paint, I use Duplicolor wipes and Adhesion Promoter Primer. That Bondo glazing will adhere to primers rather well too although I have not tried it on the adhesion promoter that I can recall.