OK… So I’m finishing up the fin can portion of my LOC 4in AMRAAM build and I’ve run into a bit of a dilemma.
Will epoxying the top CR/recovery eyelet to the fin can by applying an epoxy to the inside and outside of the MMT(inside radius), then epoxying CR to the inside of the coupler going to be strong enough? Just the 3 points of attachment. I’ll attach the next section with screws. My mind says it should be ok or it’ll work but only for a limited # of launches. Possibly damage the attached section? but I’m wondering what are other peoples thoughts?
I appreciate the wisdom from more experienced Builders.
Rob
Will epoxying the top CR/recovery eyelet to the fin can by applying an epoxy to the inside and outside of the MMT(inside radius), then epoxying CR to the inside of the coupler going to be strong enough? Just the 3 points of attachment. I’ll attach the next section with screws. My mind says it should be ok or it’ll work but only for a limited # of launches. Possibly damage the attached section? but I’m wondering what are other peoples thoughts?
I appreciate the wisdom from more experienced Builders.
Rob