Hi All,
Just wondering what size you all prefer your altimeter's to be? Or if it matters...
I see the existing products all range in size quite alot.
Ive had suggestions of 1" x 4" which seems about right to me.
Currently my board design is 1.25" x 5" (same size as the CPR3000 system) but im in the process of compacting it
Also, mtwieg has been working very hard to teach me about op-amp's and FET's and has been a huge help!
The op-amps are for the continuity test and allow the device to detect carbon build up on the terminals.
However, these op-amp's take up a fair amount of board space and i'm wondering whats more important to you all;
-smaller board with simple cont. test (could detect continuity incorrectly if enough carbon builds up...)
OR
-slightly larger board with funky cont. test?
Thanks for the input,
Alec
Just wondering what size you all prefer your altimeter's to be? Or if it matters...
I see the existing products all range in size quite alot.
Ive had suggestions of 1" x 4" which seems about right to me.
Currently my board design is 1.25" x 5" (same size as the CPR3000 system) but im in the process of compacting it
Also, mtwieg has been working very hard to teach me about op-amp's and FET's and has been a huge help!
The op-amps are for the continuity test and allow the device to detect carbon build up on the terminals.
However, these op-amp's take up a fair amount of board space and i'm wondering whats more important to you all;
-smaller board with simple cont. test (could detect continuity incorrectly if enough carbon builds up...)
OR
-slightly larger board with funky cont. test?
Thanks for the input,
Alec