I recently spotted JB Weld brand blue and red thread locker. Using the blue and it looks pretty good.
Looking forward to seeing the X-Ray boost.
For retention clips of that length I use 18 ga stainless sheet. ( Cut to length for forming and 3/8" to 1/2" wide) It's a lot easier to work with than that size aluminum stock. The only difference is that I bend the end that goes on the motor in to a "U" channel so that the aft closure is trapped. I know 18.ga doesn't sound like much but I've had it hold up to K700s with no deformation of the clips. (x2) I've even held J350s in with one with no problems. The "U" is the secret since it doesn't allow the clip to wiggle loose or kick to the side.
Even Barbie doesn't have a rocket.
Well done, sir!
https://www.rocketryforum.com/showthread.php?13829-Project-Astronaut-Barbie&highlight=Barbie+dollEven Barbie doesn't have a rocket.
Well done, sir!
Nice job Norm..I see you and paint seem to be getting along now????She could have, if she wasn't so danged tall.
https://www.rocketryforum.com/showthread.php?13829-Project-Astronaut-Barbie&highlight=Barbie+doll
Nice job Norm..I see you and paint seem to be getting along now????
Well Barbie may not have a rocket but she sports a mean space suit.
X-Ray has a passenger!
Please post pictures post launch, I want to see the effect on her hair LOL.
Enter your email address to join: