Bone Daddy
Well-Known Member
- Joined
- Oct 3, 2009
- Messages
- 928
- Reaction score
- 4
Launch it off a piston or from a tower. You could also install launch lugs inside the tube fins (on the sides opposite the body tube), but it might be a good idea to add them to two or three of the tubes, and then launch it from a specially constructed pad (or pad adapter) that has two or three rods. My concern is that if you use just one lug mounted inside of a tube fin, it will be so far off center that it will interfere with the boost off the pad. Not to mention the fact that mounting a single lug so low is a bad idea anyway.
A third idea is to use a pair of wire loops on the ends of stems, one mounted just above a tube fin and the other mounted just below the payload section.
MarkII
Enter your email address to join: