Sooner Boomer
Well-Known Member
- Joined
- Mar 21, 2011
- Messages
- 5,886
- Reaction score
- 4,845
I need a set of tubular punches to cut rings and disks from matte board or cardboard. They would need an inside chamfer to cut centering rings, or an outside chamfer to cut disks. I could use pairs for BT-5, BT-20, and BT-50 (common motor mount sizes). These would make cutting centering rings for clusters a LOT easier.
What special tools are on your wish list?
What special tools are on your wish list?
Last edited: