I was already planning on picking up an AT L900 Dark Matter load and Cert 3 XL parachute from my good buddy Juan at this launch, and he delivered Sat. morning as planned. He was also lending me a brand new Dr. Rockets 54/1706 casing so Sharon and I could drag race our 3" Darkstars. SARA didn't have two pads that would accommodate that, but I still scored three K456 DM loads from Bay Area Rocketry. Mike was a great vendor, with lots of stuff to pick through. Picked up a 60" Iris Fruity chute for the 5" Jart, and a spare 54mm seal disk. Looking around in his trailer, I found a box full of Q2G2 igniters that have been out of stock at Quest for months. Got a 24 pack for $25, which is about the same price Quest sells them for. Sharon got the new Estes altimeter and a Bay area rocketry polo shirt. I came back later and got one of the new AT single use motors, an H115 Dark Matter, you might think I like that propellant....
The BIG score was today after we had packed up and were saying our goodbye's to Roy P. He had a bunch of stuff he was selling for Gerald M. (Skippy). Went through the recovery box first, found two Top Flight chutes 96" and 80", a Classic Sky angle 44" and a slightly crispy 24" drogue. Then Sharon picked out a lavender R4C chute, and started digging through the bottom of the box for a 20 ft. piece of 1" tubular nylon with sewn loops that might work for my DS Ultimate build. We also scored a roll of 5/8" TN with at least 200 ft. on the roll.
We thought we were done when Roy pulled out another box with motor cases in it. Now I have my own Dr. Rockets 54/1706 case complete with seal disk and closures, another DR 54/852 with plugged forward closure and rear closure. Found a new 38 6xl CTI casing still in the plastic cover and another plugged closure for AT 38mm. All for about half price.
Just that morning over coffee we had been talking about getting the 54/1706 casing from Balsa Machining, so we could drag our Darkstars without borrowing a casing, and I was lusting over Juan's Dr. Rockets case. Funny how things work out.
The BIG score was today after we had packed up and were saying our goodbye's to Roy P. He had a bunch of stuff he was selling for Gerald M. (Skippy). Went through the recovery box first, found two Top Flight chutes 96" and 80", a Classic Sky angle 44" and a slightly crispy 24" drogue. Then Sharon picked out a lavender R4C chute, and started digging through the bottom of the box for a 20 ft. piece of 1" tubular nylon with sewn loops that might work for my DS Ultimate build. We also scored a roll of 5/8" TN with at least 200 ft. on the roll.
We thought we were done when Roy pulled out another box with motor cases in it. Now I have my own Dr. Rockets 54/1706 case complete with seal disk and closures, another DR 54/852 with plugged forward closure and rear closure. Found a new 38 6xl CTI casing still in the plastic cover and another plugged closure for AT 38mm. All for about half price.
Just that morning over coffee we had been talking about getting the 54/1706 casing from Balsa Machining, so we could drag our Darkstars without borrowing a casing, and I was lusting over Juan's Dr. Rockets case. Funny how things work out.