Going to start work on this boy:
6" Diameter, and I'd like to do a 29 mm cluster motor config, thus:
Estes BP motors, outer six will be F15's, center will be an F50 (for a bit more kick off the pad). My concern is the fins. With the curves, tabs for the fin pod support (no motors!), and thru-the-boat-tail-wall, they'll be complicated. I'd like to do G10, but I've not requested curved fins from a vendor before. Can somebody like Public Missiles pull that off? Here's the RockSim:
6" Diameter, and I'd like to do a 29 mm cluster motor config, thus:
Estes BP motors, outer six will be F15's, center will be an F50 (for a bit more kick off the pad). My concern is the fins. With the curves, tabs for the fin pod support (no motors!), and thru-the-boat-tail-wall, they'll be complicated. I'd like to do G10, but I've not requested curved fins from a vendor before. Can somebody like Public Missiles pull that off? Here's the RockSim: