SoCalChris
Well-Known Member
- Joined
- Dec 9, 2015
- Messages
- 95
- Reaction score
- 2
I recently finished an Eggfinder Mini, and went to program it.
I followed the instruction to remove the solder bridge on RUN, and create a bridge on PGM. I hook up the programming cable from the LCD receiver to the Eggfinder Mini. I go into programming mode, and can successfully set the frequency. However, after the following step when setting the ID, the LCD freezes, and both the red and yellow LEDs on the receiver board illuminate solid until I turn it off. Additionally, the screen freezes. If I try this with my regular Egggfinder, it has no problem and tells me to reset the receiver for changes to take effect.
On the EggFinder Mini:
Any suggestions what I might have done wrong, or where to start looking would be greatly appreciated.
Thanks
I followed the instruction to remove the solder bridge on RUN, and create a bridge on PGM. I hook up the programming cable from the LCD receiver to the Eggfinder Mini. I go into programming mode, and can successfully set the frequency. However, after the following step when setting the ID, the LCD freezes, and both the red and yellow LEDs on the receiver board illuminate solid until I turn it off. Additionally, the screen freezes. If I try this with my regular Egggfinder, it has no problem and tells me to reset the receiver for changes to take effect.
On the EggFinder Mini:
- When I initially turn it on, the two LEDs on the radio board illuminate briefly
- The large amber LED is dark for a few minutes. After a few minutes, it begins flashing amber.
- The receiver never connects with the transmitter, it just stays stuck at "Waiting for fix"
Any suggestions what I might have done wrong, or where to start looking would be greatly appreciated.
Thanks