Bryan XJ6C
Active Member
I'm looking for suggestions for methods for masking and painting body wraps that have the small vertical ribs like the Estes SaturnV has. I'm practicing on a set of extra wraps that I have. So far I've tested regular masking tape, Tamiya, and Scotch tape. I've found the Tamiya to work the best so far but it is a tedious process. It has to be attached very tightly and I've been selling the edges with Testers plastic Cement which works okay but I might try just a clear enamel since it would probably be a little heavier and fill the edge a little better. After sealing the edge of the tape I spray with a spray can. Again I'm testing on different methods and materials to try and find the least difficult and most effective materials, methods or process.
I would welcome any suggestions including any link to another post. I have read Chis Mickielsons built and it is very good but I that build was some while back and certainly other builders may have found another way.
Thanks you
Bryan
I would welcome any suggestions including any link to another post. I have read Chis Mickielsons built and it is very good but I that build was some while back and certainly other builders may have found another way.
Thanks you
Bryan