SOLD---
Missile Works--WRC2--2CH Wireless Remote Control
Ideally suited for redundant recovery system backup or remote aerial staging applications
No FCC licensing required / Part 15 compliant
Digitally encoded 900 MHz spread spectrum operation
Robust, redundant communications protocol ensures high reliability
2 independent remote control channels with 12 amp FET outputs
Maximum 2 mile line of sight in air operation with 300mw transmitter power
16 bit exclusive transmitter ID allows independent operation / no impounding R/C units
Single pushbutton operation - no ON/OFF or toggle switch combinations required
Audible ejection charge continuity check with 10 μa sample current
Dual antenna system integral to receiver board / no external antenna required
Compression terminal strips for battery, external switch, and ejection charge wiring
DL-123A 3V lithium battery included for transmitter rated for 1-2 years continuous operation
11-14 Vdc external battery required with 40 ma quiescent @ 12Vdc
Receiver board dimensions - 3.25" width x 5.5" long
Receiver weighs only 2.8 oz.
Updated and tested by Missile works
I only used it 3 times, tested today, perfect operation
Data sheets and Manual included.
Includes 2 Reusable Charge Cup Holders
$175
Can meet up within the Fort Myers, Tampa or Orlando areas.
SHIPPING AVAILABLE, BUYER PAYS TRANSFER FEES & SHIPPING.
Missile Works--WRC2--2CH Wireless Remote Control
Ideally suited for redundant recovery system backup or remote aerial staging applications
No FCC licensing required / Part 15 compliant
Digitally encoded 900 MHz spread spectrum operation
Robust, redundant communications protocol ensures high reliability
2 independent remote control channels with 12 amp FET outputs
Maximum 2 mile line of sight in air operation with 300mw transmitter power
16 bit exclusive transmitter ID allows independent operation / no impounding R/C units
Single pushbutton operation - no ON/OFF or toggle switch combinations required
Audible ejection charge continuity check with 10 μa sample current
Dual antenna system integral to receiver board / no external antenna required
Compression terminal strips for battery, external switch, and ejection charge wiring
DL-123A 3V lithium battery included for transmitter rated for 1-2 years continuous operation
11-14 Vdc external battery required with 40 ma quiescent @ 12Vdc
Receiver board dimensions - 3.25" width x 5.5" long
Receiver weighs only 2.8 oz.
Updated and tested by Missile works
I only used it 3 times, tested today, perfect operation
Data sheets and Manual included.
Includes 2 Reusable Charge Cup Holders
$175
Can meet up within the Fort Myers, Tampa or Orlando areas.
SHIPPING AVAILABLE, BUYER PAYS TRANSFER FEES & SHIPPING.
Attachments
Last edited:
