JeffofSpace
Member
- Joined
- May 6, 2013
- Messages
- 21
- Reaction score
- 0
Hi All!
This is my first post. I am about finished with my first MPR with much much help from trolling these forums...huge thanks to all for your expertise!
I attached fins without permanently securing the aft centering ring as suggested by so many on these forums...was able to get internal fillets on both the motor tube and inside body tube (after this photo). I am now ready to attach the aft cr, and am wondering if I should attach it 1/8th inch in on the motor mount as the instructions state? Or, should I push it up the extra 1/4 inch or so and make it butt up against the bottom of the fin tabs (and epoxy to the tabs)?
Further, I am using the mma-2 adapter (will do G80-7 for first flight), but the adapter makes the motor stick out an inch lower than the stock mount...do I need to worry about changes in cg or cp with the motor lower?
Huge thanks in advance!
This is my first post. I am about finished with my first MPR with much much help from trolling these forums...huge thanks to all for your expertise!
I attached fins without permanently securing the aft centering ring as suggested by so many on these forums...was able to get internal fillets on both the motor tube and inside body tube (after this photo). I am now ready to attach the aft cr, and am wondering if I should attach it 1/8th inch in on the motor mount as the instructions state? Or, should I push it up the extra 1/4 inch or so and make it butt up against the bottom of the fin tabs (and epoxy to the tabs)?
Further, I am using the mma-2 adapter (will do G80-7 for first flight), but the adapter makes the motor stick out an inch lower than the stock mount...do I need to worry about changes in cg or cp with the motor lower?
Huge thanks in advance!
Last edited: