The disadvantage of that method is that the wood filler doesn't add any strength to the joint, whereas using glue does.I tried this on an old piece of bt-60 and a launch lug.
I took some wood filler, added just enough water to make it like cake frosting, put it in a zip lock bag, cut a very small hole in one corner of the bag, and squeezed gently just like I was using glue to make a fillet. It takes a while to dry, but then I sanded it with very fine sand paper and it looks great. If I knew how to affix a picture with this I'd show you how it looks.
Andrew From Texas
Anyone have a great idea on how to keep from getting air bubbles in the launch lug fillets? I have tried everything I know with little or no luck.
Andrew From Texas
OK, here is what I did. I glued on the launch lug as usual, using wood glue. Put fillets on the lug, twice as usual. Then after that was good and cured, then I used the wood filler over the wood glue.
Hope this clears up what I did.
Thanks for the input.
Andrew
Where can you get this glue?
Andrew
Use Titebond Moulding and Trim Glue (TMTG)-- the stuff is great! Goes on smooth and slick, and it's thicker than regular white glue so it WILL NOT RUN around the ends of the launch lugs-- it stays where you put it and doesn't form bubbles or shrink anywhere near as much as regular white or yellow glue as it dries.
I usually use a double-glue joint with yellow glue to put the lug on the body of the rocket (since I usually use double-lugs, a shorter one 'up front' and a second in a fin fillet) and then after they've dried go back and fillet the lugs with TMTG. When it's done it looks every bit as good as epoxy fillets with none of the epoxy hassles or weight. The TMTG makes killer fin fillets as well...
Highly recommend it! OL JR
OK, here is what I did. I glued on the launch lug as usual, using wood glue. Put fillets on the lug, twice as usual. Then after that was good and cured, then I used the wood filler over the wood glue.
Ace Hardware carries it; that's where I got mine.I think I posted that about trim & molding glue not available at home depot. Looked there recently and didnt see it. Bought it at Lowes. We also have Menards around here and saw it there too. Havent been to Ace so dont know about there
I have done that, too, on occasion. It works!OK, here is what I did. I glued on the launch lug as usual, using wood glue. Put fillets on the lug, twice as usual. Then after that was good and cured, then I used the wood filler over the wood glue.
Hope this clears up what I did.
Thanks for the input.
Andrew
Enter your email address to join: