Yukon@K-9 Rocket Tech
Student, Drone and Rockets, Aspiring Engineer
Hi Everyone! I have been working on this launch pad where the awesome factor highly outweighs the practicality of this system. It consists of a launch pad, and controller. besides the main structure which is made of wood, most of it is 3d printed. The pad has 4 leds and 2 spot lights (one isn't wired yet). It also has a back support which still needs a linear actuator to pull back before launch, and a working clamp. I'm also working on the flame trench with a water deluge system. The launch controller is WIP also, with a estimated half mile of range. I just wanted to see what everyone thinks of it. Are there tings I should be aware of? This is my first launch pad I ever built, and I would like the communities feedback. Thanks!
Before I go, I want to know how much people want me to open source this launch pad like my other projects
-Yukon
P.S. Also I'm a Newbie forum member, so may make a few mistakes
Before I go, I want to know how much people want me to open source this launch pad like my other projects
-Yukon
P.S. Also I'm a Newbie forum member, so may make a few mistakes