ColumbiaNX01
Red blooded white American male
Hey everyone. I have a problem I have always had trouble painting polyurethane nose cones from Aerotech, LOC, and Madcow. This last time I had some to paint, I used Valspar clear plastic primer 2 coats then 2 coats of Valspar gloss back. When it was all said and done the paint still flacked off when anything rough touched the nose cones, for example my finger rubbbing against the nose cone. I painted them in room temperature conditions and waited 15 minutes between coats of primer than I painted the black paint the next day and waited 15 between two coats and let it sit in room temperature for a few days and here I am now, the paint peels off.
Am I missing anything, everything I did, I told you in the paragraph above. Is there anything that you guys suggest I do to get a good qaulity paint job on polyurethane nosecones??? I figure the paint I am using is from Lowe's and it is quality paint. I am wondering if I am missing something when I am preping the nosecones before paint.
Am I missing anything, everything I did, I told you in the paragraph above. Is there anything that you guys suggest I do to get a good qaulity paint job on polyurethane nosecones??? I figure the paint I am using is from Lowe's and it is quality paint. I am wondering if I am missing something when I am preping the nosecones before paint.