Vanel
Well-Known Member
- Joined
- Jan 19, 2009
- Messages
- 536
- Reaction score
- 0
I have been working on my 1st 2 Dr. Zooch kits - the Discoverer Thor and the Ares 1. Both are fun builds - the Thor is very straightforward. However, I have a question on the Ares... The instructions call for cutting several thin (1/16") thin strips of paper to simulate the SRB segment joints, but the spacing in the diagram and that given in the instructions don't jive?
Doc, can you clarify please?
And yes, I work for NASA ( If you read the Ares instructions, you'll understand).
P.S. - Thank you, Mods. I can post again
Doc, can you clarify please?
And yes, I work for NASA ( If you read the Ares instructions, you'll understand).
P.S. - Thank you, Mods. I can post again