Chris TNR
Well-Known Member
- Joined
- Oct 29, 2005
- Messages
- 231
- Reaction score
- 0
It seems that I've been given the laborious task of sanding the Airfoils on all the Team members fins and I have a lot of them I have a lathe that has a 7" disc sander on the opposite side of the drive center that I use for this task, and a jury made jig (set @7 degree angle) that can handle only smaller fins. Yep....I sand my fingers a lot too....
Unfortunately, this time around I have numerous large fins to sand airfoils on, and a new jig that will handle larger fins is definitely required.
Although I have a few ideas in mind, I still felt compelled to ask if anyone has any suggestions, or even references on how I might acquire drawings of one.
Thanks in advance............
__________________________
Chris Emich
NAR #84102
Team Nitrus Rocketry
Machinist
__________________________
In the Works...........
8" Dia. Upscale Bulldog L3 Cert. Rocket
Known As: Bulldragon
Unfortunately, this time around I have numerous large fins to sand airfoils on, and a new jig that will handle larger fins is definitely required.
Although I have a few ideas in mind, I still felt compelled to ask if anyone has any suggestions, or even references on how I might acquire drawings of one.
Thanks in advance............
__________________________
Chris Emich
NAR #84102
Team Nitrus Rocketry
Machinist
__________________________
In the Works...........
8" Dia. Upscale Bulldog L3 Cert. Rocket
Known As: Bulldragon