Stones
Well-Known Member
- Joined
- Aug 15, 2012
- Messages
- 1,843
- Reaction score
- 1
I'm about to do an upscale of the Phoenix and will be using LOC BT, NC, and CR's. I'm going for the t-nut and some sort of clip motor retention method. I will be using RMS and SU motors. 29mm up to and including H impulse.
Here's a few questions I have for the masses....
Is there a specific rule of thumb on how far to space the t-nuts(#6) from the center of the MMT?
I will more than likely make seperate clips for each of the RMS and SU applications.
Should I NOT install a motor block in the MMT?
tia...
Here's a few questions I have for the masses....
Is there a specific rule of thumb on how far to space the t-nuts(#6) from the center of the MMT?
I will more than likely make seperate clips for each of the RMS and SU applications.
Should I NOT install a motor block in the MMT?
tia...