- Joined
- Sep 24, 2018
- Messages
- 152
- Reaction score
- 114
So after using my stock Creality CR-10 v2 for years I decided it was time for an update.
I added a Swiss Micro NG Direct Drive Extruder / hotend and installed Klipper with my raspberry pi. I also moved the filament from the side to above the printer.
It took some time to get Klipper configured but I am very happy with the results. I have not tried speeding up the print yet.
I am still using octoprint but I have been looking at installing Mainsail.
I think I am going to be happy with the new setup. Less filament clogs and breaks and more reliable, consistent prints.
I added a Swiss Micro NG Direct Drive Extruder / hotend and installed Klipper with my raspberry pi. I also moved the filament from the side to above the printer.
It took some time to get Klipper configured but I am very happy with the results. I have not tried speeding up the print yet.
I am still using octoprint but I have been looking at installing Mainsail.
I think I am going to be happy with the new setup. Less filament clogs and breaks and more reliable, consistent prints.