lakeroadster
When in doubt... build hell-for-stout!
Couple of questions:
As always, thanks for helping me through my BAR phase
- What grit sandpaper do you use to sand down the CWF?
- Do you chuck the nose cone into a drill press to sand it, thus to ensure profile?
- An idea came to me for the cockpit (see photo below).. since it's simply a small contoured balsa piece, couldn't I glue it to the body with wood glue and then simply seal it with CA?
- Do you folks rough up the body surface at balsa attachment points, or is that not required?
As always, thanks for helping me through my BAR phase