chipotle mg
Member
- Joined
- Feb 22, 2022
- Messages
- 18
- Reaction score
- 13
Hi everyone, I am new to the hobby and have limited experience. I have built and launched a few low powered cardboard/plastic rockets with varying levels of success. It has so far been a fun learning expereince. I would like to try to plan a build for a L1 attempt that would also be viable for a L2 attempt in the future. If the rocket and my interests make it that far I would attend one of the National launches like Balls or LDRS and try to max out the altitude with it. The reason being to save money and not have lots of obsolete rockets in short order. Also I have a collection of paper cardboard rockets now that are taking up space in my house as my aspirations grow. So can you give me advice on what I should do or what you would do if you had a similar idea.
To start you off I have considered getting a Wildman Punisher 3" kit with a 54mm motor mount. perhaps I could get a motor reducer sleeve to 38mm for the H or I L1 and just have a motor eject for the L1. Later I could put in the avionics bay and go for the L2 with most of the other parts. OR maybe I could attempt dual deply and the L1 and use and I motor for the L1 at the same time and not have to tinker too much for the L2 at a later date.
I have put some thought into it but my mind is a bit disorganzied at the moment. Any comments are appreciated and considered.
To start you off I have considered getting a Wildman Punisher 3" kit with a 54mm motor mount. perhaps I could get a motor reducer sleeve to 38mm for the H or I L1 and just have a motor eject for the L1. Later I could put in the avionics bay and go for the L2 with most of the other parts. OR maybe I could attempt dual deply and the L1 and use and I motor for the L1 at the same time and not have to tinker too much for the L2 at a later date.
I have put some thought into it but my mind is a bit disorganzied at the moment. Any comments are appreciated and considered.