Not sure if I have this thread in the right place.
I made a curing oven which was inspired by another rocketeer Justin.
I made some changes to make it more stout and interchangeable for rocket diameter. I know it will do 4” or less but not so sure on 5”
It is 24” high x 24” deep and 16” wide.
Glued together and used general purpose foil tape throughout the inside.
Top comes off and remove one side panel and slip the tube through.
I have two 200 watt bulbs and the thermostat is relatively inexpensive from Amazon. I am able to heat up and keep it around 220. Turns off and on to keep it within 5 degrees.
I made a curing oven which was inspired by another rocketeer Justin.
I made some changes to make it more stout and interchangeable for rocket diameter. I know it will do 4” or less but not so sure on 5”
It is 24” high x 24” deep and 16” wide.
Glued together and used general purpose foil tape throughout the inside.
Top comes off and remove one side panel and slip the tube through.
I have two 200 watt bulbs and the thermostat is relatively inexpensive from Amazon. I am able to heat up and keep it around 220. Turns off and on to keep it within 5 degrees.
