I took 4 jumbo paper clips, which are about 1 7/8" long and bent them, so that one side will be glued to the wing and one side will be attached to the elevon. The first clip was attached with epoxy and no paper. The second clip was attached with epoxy and paper on top and more epoxy on top of the paper. These were on one glider placed outward near the wing tips. The next two clips were attached more inward on the other glider so as to not interfere with the first glider. They had the 20 pound stationery placed on top with no epoxy on top of the paper. These last two attachments look much better. I have not attached the other side of the bent clip to the elevons. I am thinking of using hinge tape for that attachment, which would be less work. In any case once the clips are attached the elevons can be set up as a little bit of elevon up-flap on both gliders prior to launch. In the launch configuration the up-flap on both gliders will cancel out on boost. When the gliders separate, each glider will have the elevons already in place for gliding.