I have an Aluminum ( 6061 ) pipe, 2" in diameter x 2' long, i need the ends faced and deburred. I know there are lots of machinist on TRF so i thought i would ask here.
Last edited:
You can become a Supporting Member which comes with a decal or just click here to donate.
Thanks, i updated my post. it's 2' longHow long are the pieces of 2" pipe? That will make a big difference for the machinists ability to work on them.
Anything else? Snapring groves? Holes? Tapping?Thanks, i updated my post. it's 2' long
i do need holes drilled and tapped but was planning to do that myself. If it's not worth the time to just square off the ends then yeah, 16 holes drilled/tapped as well. I can supply a fusion360 file with everything laid out. If that goes ok then there's 3 other components that need lathe work coming right behind the tube.Anything else? Snapring groves? Holes? Tapping?
If you don't have any luck here, you might try the Dallas MakerSpace.i do need holes drilled and tapped but was planning to do that myself. If it's not worth the time to just square off the ends then yeah, 16 holes drilled/tapped as well. I can supply a fusion360 file with everything laid out. If that goes ok then there's 3 other components that need lathe work coming right behind the tube.
Enter your email address to join: