I am building a minimum diameter Wildman 3" rocket. I will be using an Adaptive Aerospace 54mm printed altimeter sled. I would like to mount a Missile Works RRC3 on one side, and a PerfectFlite StattologgerCF on the back. I am trying to figure out how to power them both with the one 9V sized battery holder. The RRC3 will run on 3.7V, but the StattologgerCF requires higher voltage.
1) I could power the altimeters in parallel from a standard 9V alkaline battery.
2) I could try to fit LiPo into the holder. A 1S 3.7V to the RRC3, and either a 2S 7.4V or two 1S in series to the StattologgerCF, and all these together must be the size of a 9V battery or less.
Electronics are not my strong point. Would this work? Anyone done this?
Dale
1) I could power the altimeters in parallel from a standard 9V alkaline battery.
2) I could try to fit LiPo into the holder. A 1S 3.7V to the RRC3, and either a 2S 7.4V or two 1S in series to the StattologgerCF, and all these together must be the size of a 9V battery or less.
Electronics are not my strong point. Would this work? Anyone done this?
Dale