By golly it worked Igor!
Over the weekend I converted a Flis MMX Stinger into a 3 motor clustered Stinger.
About the only real trouble I ran into was adding the outboard motor tubing changed the angle of the rear bulkhead a bit which required a little addition to the folded cardstock shroud. The total mass added including the bits of shroud overlay amounted to .5g which I'll add in nose weight when I swing test the model in the next day for so.
I have the unpainted Build photos downloaded from the camera but haven't labled or resized them as yet. will add them ASAP.
Edit:
busy morning..one pic is all I've had a chance to process, more later.
Edit:
another before sanding pic
Over the weekend I converted a Flis MMX Stinger into a 3 motor clustered Stinger.
About the only real trouble I ran into was adding the outboard motor tubing changed the angle of the rear bulkhead a bit which required a little addition to the folded cardstock shroud. The total mass added including the bits of shroud overlay amounted to .5g which I'll add in nose weight when I swing test the model in the next day for so.
I have the unpainted Build photos downloaded from the camera but haven't labled or resized them as yet. will add them ASAP.
Edit:
busy morning..one pic is all I've had a chance to process, more later.
Edit:
another before sanding pic
Last edited: