I am building a Trajector which is to be wrapped in Accur8 skins. It occurred to me that I'm not sure what the best shock cord upgrade would be for these E2X PSII models. When building LPR I do the standard Kevlar loop around the motor mount, tied to elastic just below the top of the BT. Then I looked at the plastic centering rings and realized that I haven't actually seen if folks do the same thing with these, or if there is a different technique called for.
Also, the Kevlar I have on-hand is about 130 lb, I'm guessing you'd normally use a bit heavier on these? I was thinking of just doubling it rather than buying new just for this one rocket.
For what its worth, I expect to fly this mainly on Estes BP E and F motors.
Any input here appreciated.
Also, the Kevlar I have on-hand is about 130 lb, I'm guessing you'd normally use a bit heavier on these? I was thinking of just doubling it rather than buying new just for this one rocket.
For what its worth, I expect to fly this mainly on Estes BP E and F motors.
Any input here appreciated.