MadRocketer
Determined to do it differently
I got some more work done late last night. Cut the shoulder on the Fin can after hollowing out more material.
The burn marks on the shoulder are where I test fit the nose cone. I very carefully slid it on while it was spinning, the friction burning the high spots. Trimmed that down and have a bit of a loose fit now, but some tape can fix that.
The burn marks on the shoulder are where I test fit the nose cone. I very carefully slid it on while it was spinning, the friction burning the high spots. Trimmed that down and have a bit of a loose fit now, but some tape can fix that.