russell_t
Well-Known Member
- Joined
- Feb 15, 2019
- Messages
- 120
- Reaction score
- 314
3D Printing Vintage Launch Controller
- Thread starter russell_t
- Start date
Help Support The Rocketry Forum:
Yes, the old Astron controller. Worked very well.
shockie
High Plains Rocketeer
Do you have a dimension drawing pattern for the copper connection pieces?
russell_t
Well-Known Member
- Joined
- Feb 15, 2019
- Messages
- 120
- Reaction score
- 314
@shockie The three pieces of internal hardware were traced using a borrowed controller. The tracings were cut out and used as templates for fabricating prototypes from a sheet of 28 gauge brass. Additional info was posted in the Thingiverse link to the controller. A copy of the tracings is attached here, with markings for printing to scale.
