Eyeguy41
Well-Known Member
- Joined
- Jan 20, 2013
- Messages
- 85
- Reaction score
- 1
I would like to add shear pins to mu LOC Hyperloc 300. It is phenolic tube, my concern is how do I strengthen the cardboard so that the shear pins don't continually ream out the hole that the pin is screwed into.
What hardware are you using and how are you installing it.
I was planning on using 2-56 nylon screws but didn't want to screw straight into the tube. I thought about tee nuts but I can't find them in the 2-56 size. Really curious what everyone else is doing. This forum is a wealth of knowledge and I could not have gotten as far as I have without it. Thanks in Advance.
What hardware are you using and how are you installing it.
I was planning on using 2-56 nylon screws but didn't want to screw straight into the tube. I thought about tee nuts but I can't find them in the 2-56 size. Really curious what everyone else is doing. This forum is a wealth of knowledge and I could not have gotten as far as I have without it. Thanks in Advance.