glad im not the only one who did this! Yeah it could have been more clear that they wont fit the tubes from LOC kits, but i have alot of respect Robert at buyrocketmotors. im sure if i messaged him he'd make it right, but ill shave it down to fit the LOC tube. increased surface area for the epoxy makes sense.Correct, not threads but for epoxy to hold onto.
For each size motor retainer there are several Motor Tube sizes. Getting the correct one is not easy since most do NOT list the OD of the part the should match the MMT.
Did the same thing you did, Buy a LOC kit from BuyRocketMotors and bought their retainer only to find out that it DOES NOT FIT LOC tubing.
I leaft a Bad review of their retainer but it was NO
If the retainer ID is just a little smaller then you could sand out the ID to fit the MMT, remove 0.020" of ID.
Else, return this one and buy one that fits LOC tubing.
The description clearly indicates what the retainer fits. It is ridiculous that you made the mistake and then do a bad review.Buy a LOC kit from BuyRocketMotors and bought their retainer only to find out that it DOES NOT FIT LOC tubing.
I leaft a Bad review of their retainer but it was NO
That description was NOT on the item last year when those retainers where introduced.The description clearly indicates what the retainer fits. It is ridiculous that you made the mistake and then do a bad review.
They "snugly" fit their filament wound glass-fiber tubes which lists the OD +/- .003. They have no need to list the ID of the retainer. If I did not see the description last year, I cannot respond to your first statement. Regardless, the information is there if you bother to look.That description was NOT on the item last year when those retainers where introduced.
They still do NOT list the ID.....
Enter your email address to join: