M1340W DMS

[dshmel]

I cannot find any assembly diagrams or other info on the 98mm M1340. Is this DMS motor complete or do you need to provide a standard forward or aft retainer from an RMS case?

 

[tfish]

https://www.aerotech-rocketry.com/uploads/3e44d803-bfd3-4d33-958e-96f1d5ff59f0_75 & 98mm DMS Instructions 1-26-17 Small.pdf

The photo is one I refurbished into an "Inert" motor. For show and tell.

Tony

 

[dshmel]

Thanks, the instructions don't show the thrust ring on the aft end of the motor. But your photo clearly shows a thrust ring molded onto the case. I assume.

 

[Keisling]

https://www.aerotech-rocketry.com/uploads/3e44d803-bfd3-4d33-958e-96f1d5ff59f0_75 & 98mm DMS Instructions 1-26-17 Small.pdf

The photo is one I refurbished into an "Inert" motor. For show and tell.

Tony

That's super cool, Tony!

 

[crossfire]

So the grains are bonded ?

 

[boatgeek]

I like the demo case. It took me a moment to figure out you hadn't actually taken a bandsaw to an M motor.

BTW, the assembly instructions really should show the person wearing gloves while mixing and pouring the epoxy.

 

[AeroTech]

I cannot find any assembly diagrams or other info on the 98mm M1340. Is this DMS motor complete or do you need to provide a standard forward or aft retainer from an RMS case?

https://d11fdyfhxcs9cr.cloudfront.net/templates/170652/myimages/m1340w-ps_rcs_assembly.pdf