I'll add more pics and organization as I go.
Here's a link to the basic information file. https://docs.google.com/document/d/1T7NLmEyboIeUgveng9yrV8AqFyct7YarYccKQoEnlNs/edit?usp=sharing
But this happened and I thought you guys might have more ideas...
I put the initial epoxy on the centering rings. I was testing the fit and discovered that I managed to get the aft ring on about 1/4 inch too far aft. This will cause some issues with the injected filets, so I stopped there.
I could cut a new CR in half to install it in the proper location.
I could CA some stops in to keep the epoxy where it belongs. Even creative masking tape might work.
I'm leaning towards just cutting a plywood CR to keep the epoxy in place. Is there a problem with that I'm not seeing? Or even foam, cardboard, etc..
Here's a link to the basic information file. https://docs.google.com/document/d/1T7NLmEyboIeUgveng9yrV8AqFyct7YarYccKQoEnlNs/edit?usp=sharing
But this happened and I thought you guys might have more ideas...
I put the initial epoxy on the centering rings. I was testing the fit and discovered that I managed to get the aft ring on about 1/4 inch too far aft. This will cause some issues with the injected filets, so I stopped there.
I could cut a new CR in half to install it in the proper location.
I could CA some stops in to keep the epoxy where it belongs. Even creative masking tape might work.
I'm leaning towards just cutting a plywood CR to keep the epoxy in place. Is there a problem with that I'm not seeing? Or even foam, cardboard, etc..
Last edited: