I was finally able to get some more done on this build now that I have some free time again. Last night I beveled the edges of the fins. I marked a line 1/4" back from the edges as a reference for sanding. I started with 100 grit on a sanding block and then progressed to 220 grit. The fins are due for another round of sanding and then sealing. I also sanded down the casting lines on the nose cone and roughed up the entire surface for paint.
View attachment 282163
View attachment 282164
I sourced some hardware for the shock cord attachment at the baffle and nose cone. For the baffle connection, I am using a 1/4" eye bolt with a 1/4" spring link. My hope is the spring link will make it easier to remove the shock cord (if needed) since the body tube is only 2.5" in diameter. At the nose cone, I am using a 3/16" eye bolt and 3/16" quick link.
View attachment 282166