conman13
Well-Known Member
- Joined
- Sep 18, 2013
- Messages
- 2,703
- Reaction score
- 77
Alright so I just purchased my Loki 75/8000 case and was in my schools composites lab rolling a fin can for my L3 project. I turned around to grab a pair of scissors and upon turning back my case was rolling off the table with a 3' drop to solid concrete floor. Upon inspection the forward closure end of the case is slightly bent in. It appears that it doesn't extend past the snap ring groove further into the case which is good. It is bent slightly enough to not allow the forward closure to fit due to the spot that must have initially impacted the floor. I've attached pictures below of the damage i'm talking about. What is the best course of action to fix this? Is it safely fixable? I know I can cut the case down to another size however I cant really afford to purchase another case being a poor college student. My entire senior design project depends on this lol.
Thanks,
Connor
Note: The snap ring still fully seats into its groove.
Thanks,
Connor
Note: The snap ring still fully seats into its groove.